Greenheck Fabra Hood, Single Section with Filters, throat length less than or equal to 72 inches (471322) - Manual (Page 3)

Step 6
Step 7
3 Fabra Hood • Form F
Step 8
Figure 5 Fabra hood Form F 471322
Figure 6 Fabra hood Form F 471322
Attach the END ANGLE (hand tight) to the ends of
the SIDE FILTER CHANNEL ASSEMBLIES and SIDE
CHANNELS using four (4)
5 ⁄
16
X 1 weldstud fasteners per
END ANGLE. (See Figure 5) In addition, units with throat
widths greater than 36 inches will require
FILTER END CHANNEL ASSEMBLIES.
(See Figure 5, DETAIL ''D'') Fasten FILTER END
CHANNEL ASSEMBLY (hand tight) to the END
CLOSURE ANGLE and END ANGLE, using two
5 ⁄
16
X 1 weldstud fasteners per assembly.
Slide FILTERS in from both ends of unit. Tighten all
FILTER CHANNEL and END ANGLE fasteners only after
FILTERS are in place.
Attach the HOOD RAIL ASSEMBLY to the HOOD
SUPPORT ANGLES using two (2)
3 ⁄
8
X 3 ⁄
4
inch fasteners
per HOOD RAIL ASSEMBLY. (See Figure 6) NOTE:
Fasteners should be hand tightened only until step 9.
Figure 5
Figure 6