Greenheck Fabra Hood, Multi Section with Filters, throat length greater than 72 inches (471324) - Manual (Page 3)

Step 6
Step 9
3 Fabra Hood • Form G
Step 7
Step 8
Figure 4 Fabra hood Form G 471324
Figure 6 Fabra hood Form G 471324
Figure 7 Fabra hood Form G 471324
Attach the END ANGLE (hand tight) to the ends of
the SIDE FILTER CHANNEL ASSEMBLIES and SIDE
CHANNELS, using four (4)
5 ⁄
16
X 1 inch weldstud
fasteners per END ANGLE. (See Figure 5)
In addition, units with throat widths greater
than 36 inches will require
FILTER END CHANNEL ASSEMBLIES. (See Figure 5,
DETAIL "D") Fasten FILTER END CHANNEL ASSEMBLY
(hand tight) to the END CLOSURE ANGLE and END
ANGLE, using two
5 ⁄
16
X 1 inch weldstud fasteners
per assembly.
Bolt together the HOOD RAIL ASSEMBLY LEFT to the
HOOD RAIL ASSEMBLY RIGHT using two (2)
5 ⁄
16
X 1 inch
fasteners per HOOD RAIL ASSEMBLY. (See Figure 6)
Slide FILTERS in from both ends of unit. Tighten all
FILTER CHANNEL and END ANGLE fasteners only after
FILTERS are in place.
Attach the HOOD RAIL ASSEMBLY to the HOOD
SUPPORT ANGLES, using two (2)
3 ⁄
8
X 3 ⁄
4
inch fasteners
per HOOD RAIL ASSEMBLY.
(See Figure 7) NOTE: Fasteners should be hand
tightened only until step 11.
Figure 5
Figure 6
Figure 7