Figure 9 – Greenheck Fabra Hood, Multi Section with Birdscreen, throat length greater than 72 inches (471323) User Manual

Page 4

Step 10

Step 11

Fabra Hood Form C and D Assembly Instructions, Rev. 2, October 2012

Figure 9 Fabra hood Form C & D 471323

Step 11 Fabra hood Form C & D 471323

Assemble HOOD PANELS to HOOD RAIL ASSEMBLY.
The HOOD END ASSEMBLY with the MALE RIB is to
be installed first. (See Figure 9, DETAIL "E") Place the
remaining HOOD PANELS in place, interlocking panels
as you go. (See DETAIL "E") Secure each HOOD PANEL
to the HOOD RAIL ASSEMBLY as it is put in place
using four (4) No. 12 X

⁄

inch sheet metal screws with

sealing washers per HOOD PANEL. The HOOD END
ASSEMBLY with the FEMALE RIB is to be installed last.
NOTE: Hoods over 9 Feet wide are supplied with

special HOOD CLIPS. (See DETAIL "F") HOOD PANELS
have predrilled holes for HOOD CLIP installation. Install
CLIPS as HOOD PANELS are being put in place using
one (1) No. 12 X

⁄

inch sheet metal screw with sealing

washer per HOOD CLIP. To install CLIPS in the last
panel, leave the END BIRDSCREEN ASSEMBLY out to
provide access to the underside of the hood. The END
BIRDSCREEN ASSEMBLY can be easily replaced after
the hood is completely assembled.

Figure 9

Tighten all pivot bracket fasteners.

NOTE: There may be extra fasteners.

Phone: (715) 359-6171 • Fax: (715) 355-2399 • E-mail: [email protected] • Website: www.greenheck.com