Greenheck Energy Recovery Filter Hood System User Manual
Page 2

Table of Contents
Receiving, Unpacking, Handling, Storage . . . . . . . . . 2
Installation
Components and Installing Control Cabinet . . . . . . 2
System
Installation
. . . . . . . . . . . . . . . . . . . . . . . . . . 3
Plumbing and Electrical Requirements . . . . . . . . . . 4
Control
Cabinet
Layout
. . . . . . . . . . . . . . . . . . . . . . 4
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Balancing and Testing Methods . . . . . . . . . . . . . . . . . 6
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Replacement Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Codes and Standards . . . . . . . . . . . . . . . . . . . . . . . . . 7
Our Commitment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Receiving - Upon receiving the product, check to make
sure all items are accounted for by referencing the bill
of lading to ensure all items were received. Inspect
each crate for shipping damage before accepting
delivery. Notify the carrier if any damage is noticed.
The carrier will make notification on the delivery
receipt acknowledging any damage to the product.
All damage should be noted on all of the copies of the
bill of lading which is countersigned by the delivering
carrier. A Carrier Inspection Report must be filled out
by the carrier upon arrival and reported to the Traffic
Department. If damaged upon arrival, file a claim
with the carrier. Any physical damage to the unit after
acceptance is not the responsibility of the manufacturer.
Unpacking - Verify that all of the required parts and
the correct quantity of each item have been received.
If any items are missing, report shortages to your local
representative to arrange for obtaining missing parts.
Sometimes it is not possible that all items for the unit
be shipped together due to availability of transportation
and truck space. Confirmation of shipment(s) must be
limited only to items on the bill of lading.
Handling - Make sure the equipment does not suffer
any heavy vibration or knocks. Handle in such a manner
as to keep from scratching or chipping any coating.
Damaged finish may reduce the ability of unit to resist
corrosion.
Storage - Products are protected against damage
during shipment. If the product must be stored prior
to installation, it must be protected from dirt and
moisture. Indoor storage is highly recommended. For
outdoor storage, cover the control package with a tarp
to keep it clean, dry. The user assumes responsibility
of the equipment and accessories while in storage. The
manufacturer will not be responsible for damage during
storage. These suggestions are provided solely as a
convenience to the user.
NOTE
Improper storage which results in damage to the unit
will void the warranty.
NOTE
It is the responsibility of the installer to ensure studs
or other structural members should be the point of
fastening when attaching this cabinet to a wall.
Installation
Components
Components included with the energy recovery filtration
system.
NOTE
All installation must follow local plumbing and
electrical codes.
Quantity Description
Varies
Two size options:
• 20 inch high x 20 inch wide (50.8 x 50.8 cm) or
• 16 inch high x 20 inch wide (40.64 x 50.8 cm)
Special energy recovery filters with quick
couplers and hoses attached
2
3/8 inch (0.95 cm) UL Listed hood penetration seal
1
18 inch (45.72 cm) stainless steel hose
1
24 inch (60.96 cm) stainless steel hose
1
24 inch high x 36 inch wide x 14 inch deep
(60.96 x 91.44 x 35.56 cm) control cabinet
1
Male disconnect
1
Female disconnect
1
Filter spacer
Installing Control Cabinet
The cabinet should be mounted to a
secure surface through the holes
around the back perimeter
of the cabinet. Use
at least six (6)
mounting holes
evenly spaced
around the back
perimeter of the
cabinet. If the
pre-drilled holes
do not work,
drill additional
holes around
the perimeter for
mounting. The
cabinet will weigh approximately 85 pounds (38.56 kg).
Energy Recovery Filter System
2