Greenheck EM Series (468391) - Manual (Page 4)

4
Multi-section Assembly
When the finished damper assembly is made up of multiple sections, the sections will require field assembly. Frame clips are
provided for this purpose. The frame clips are a snap fit component that fit over the joint between adjoining sections. The
clips will require the use of a rubber hammer or similar tool to install as shown below. Install frame clips on the front side and
backside of the assembly. For added strength, screws may be used on the backside of the frames in lieu of or in addition to
the frame clip. Do not install screws on the front side of the frame where they could interfere with the operation of the blades.
Note: Used only on EM series dampers.
Frame clip
Front side of damper blade
overlaps the frame.
Blade
Use screws here if
necessary
Vertical joint shown. Horizontal joint is similar.
Frame clip
468391• EM & GM Series Rev. 4, April 2013 Copyright 2013 © Greenheck Fan Corporation
As a result of our commitment to continuous improvement, Greenheck reserves the right to change
specifications without notice.
Specific Greenheck product warranties are located on greenheck.com within the product area tabs and in
the Library under Warranties.
®
Phone: (715) 359-6171 • Fax: (715) 355-2399 • E-mail: [email protected] • Website: www.greenheck.com
Our Commitment