DeWalt DS100 - Manual (Page 28)

English
21
LED DISPLAY CODES
Fault Code Fault Display Description Action
Power Primary Power No power to Check power supply
Lost Base Base Unit
DevPower Primary Power Lost No battery power Change battery, reset
Device # in device
BaseLowBatt Base Base Unit Plug in power supply
Low Battery battery low to recharge battery
DevLowBatt Low Battery Device battery Change battery, reset
Device # low
WeakSig Weak Signal Transmission signal Check for interference;
Device # from device is weak move device
Unsecured Unsecured Device has Check for intrusion;
Device # been tripped re-secure device
NoCheckIn No Check In Device check-in Check for interference;
Device # messages have not move device
been received
Tamper Tamper Device has been Close device or
opened or damaged replace if damaged
BaseBadBatt Bad Battery Base Unit battery has Needs to be repaired
Base dropped below the at D E WALT authorized
voltage limit service center
CellRadio Cell Radio Cellular radio Move Base Unit to
Fault signal is lost a location where
or scrambled CELL light is solid;
call Customer Service
if problem persists
Receiver Receiver Fault 2-way transmission Call customer service
Device # of device is lost to test system for issues
NetControl Base Network Base RF processor Internal check; will clear
Control communications itself; call Customer Service
if problem persists
DESCRIPTION OF FAULT CODES
LED SOLID BLINKING OFF
POWER Primary power • Primary power supply No unit power
source is present missing (steady flashes); and no battery
• Low battery (series of two power
flashes); or
• Standby state (one flash
every 5 seconds)
ARMED System is armed On an exit or entry delay System is
disarmed
CELL Cellular signal Cellular signal Little or no
is strong is weak cellular signal
CALL Call is complete Call is in progress No activity
(will remain solid
for 30 seconds)
Contact
If you have any questions or comments about this product, call us toll free at 1-800-4-
D
E WALT (1-800-433-9258); or visit www.dewalt.com. To answer any specific monitoring
questions call D E WALT customer service or refer to the monitoring service contract for
additional contact phone numbers.
Full One Year Warranty
The D E WALT Jobsite Security Portable Alarm System is warranted for one year from date
of purchase. We will repair, without charge, any defects due to faulty materials or work-
manship. For warranty repair information, visit www.dewalt.com or call 1-800-4-D
E WALT
(1-800-433-9258). This warranty does not apply to accessories or damage caused where
repairs have been made or attempted by others. This warranty gives you specific legal
rights and you may have other rights which vary in certain states or provinces.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are
missing, call 1-800-4-D
E WALT for a free replacement. See the beginning of this manual
for a list of warnings on the Base Unit and Key Chain Remote.
Patent Notification
Manufactured under one or more of the following patents.
5,587,701 5,777,551 6,441,731
5,850,180 6,049,273
Other patents may be pending.