GAMMA 6900 Els STRINGING MACHINE 2 POINT SC MOUNTING (Issue 4B - February 2014) - Manual (Page 12)

13
Special Throat Mounting
For racquets with a bridge that is thinner than
the rest of the frame or are tapered from head
to throat you may need to mount the racquet
with the shafts of the racquets supported by
the white support pads as pictured.
MOUNTING THE FRAME
STRINGING THE FRAME
Clamp Base Operation
To lock the string clamp base to the turntable,
rotate the clamp base locking lever clockwise.
To release the string clamp base from the
turntable, rotate the clamp base locking lever
counter-clockwise.
The Locking Lever should be tightened
enough to prevent clamp base slippage on
the turntable when the desired tension is
placed on the string.
String Clamp Operation
The string clamps are a dual action design
where the string clamp and clamp base oper-
ate independently of one another.
To clamp a string, lift the string clamp, place
the string between the jaws and depress
the string clamp lever to secure the string.
The clamping pressure applied to the string
should be adjusted to provide suffi cient pres-
sure to secure the string when subjected to
the desired pulling tension. The diamond
coated gripper plates provide for increased
friction between the clamps and the string
to allow for reduced clamping pressure while securing and holding the string under tension.
Note that excessive pressure can damage both the strings and String Clamp.
BRIDGE