GAMMA 6900 Els STRINGING MACHINE 2 POINT SC MOUNTING (Issue 4B - February 2014) - Manual (Page 11)

12
MOUNTING THE FRAME
Adjusting the Inner Racquet Supports
The white racquet supports are adjustable to accommodate
all racquets and provide maximum support to the racquet
frame. Screw the pads up or down so they contact the frame
at a maximum height without blocking the grommet holes.
Racquet Hold Down Clamp Operation
With the lever in the up position, insert the racquet hold
down clamp pin into the hole in the center of the mount-
ing stand. Lower the hold down clamp until it just makes
contact with the surface of the racquet. Using slight palm
pressure on the hold down clamp depress the racquet
hold down lever completely to secure the racquet frame
to the stand.
Mounting Stand Adjustment
When mounting a racquet, adjust the
Mounting Stands so that the white Racquet
Supports on top of the Mounting Stands fi t
inside the hoop of the racquet. Lower the
racquet over the Racquet Supports and ad-
just the Mounting Stands until the supports
just make contact with the inside surface of
the racquet at the head and throat. There is
an arrow on the face of each knob indicat-
ing the turning direction that will “Tighten”
the mounting points by moving the 2pt
Mounting Stands further apart to bring the
Racquet Supports closer to the inside surface of the racquet at the head and throat. Turning
the knobs in the opposite direction will move the Mounting Stands closer together and will
allow the Racquet Supports to move away from the racquet frame.