Directed Electronics AVITAL 3300L - Manual (Page 28)

23 © 2011 directed electronics—all rights reserved 23
To enter or exit Valet Mode using the remote:
Steps 2 through 3 must be quickly and smoothly completed.
1. Open any vehicle door.
2. Press
DRW-226
.
3. Press
DRW-226
.
4. Press
DRW-226
again.
The status LED will light solidly if you are entering Valet Mode,
and it will go out if you are exiting Valet Mode.
setting the clock
To set the clock press and hold
DRW-226
for five seconds, the trans-
ceiver will chirp twice and the hour selection will start flashing.
Immediately press
DRW-226
to advance the hour selection or to
reverse the hour selection. Once the correct hour is displayed
press
DRW-226
again and the minute selection will start flashing. Then
press
DRW-226
to advance the minute selection or to reverse the
minute selection. Once the correct time is displayed simply stop
pressing any buttons for 15 seconds and the transceiver will auto-
matically exit the clock mode.
nuisance prevention
®
circuitry
Your system has Directed’s Nuisance Prevention ® Circuitry
(NPC
®
). It pre vents annoying repetitive trigger sequences due
to faulty door pin switches or en vi ron men tal con di tions such as
thunder, jack ham mers, airport noise, etc.