Directed Electronics AVITAL 3300L - Manual (Page 21)

16 © 2011 directed electronics—all rights reserved 16
using your system
important: Due to the complexity of this system,
installation of this product must only be performed
by an authorized Directed dealer.
active arming
You can arm the system by pressing
DRW-226
of your remote for one
second. When the system arms, you will hear a short siren sound,
or chirp, and see the parking lights flash once. If the power door
locks are con trolled by the system, the doors will also lock. While
the sys tem is armed, the status LED will flash approximately once
per sec ond, indicating that the system is actively pro tect ing your
vehicle. If you hear a second chirp after arming and note that the
status LED is flashing in groups, see the Diagnostics Section of
this guide. This extra chirp is called Bypass No ti fi ca tion, which
indicates that a security sensor or switch has been bypassed and
the system is not monitoring that area (zone) of the vehicle.
passive arming
The system can be programmed to arm itself au to mat i cal ly (called
pas sive arming). If the system is programmed for passive arming,
it will automatically arm 30 seconds after the ignition is turned
off and the last protected entry has been closed. (e.g. the system
detects that you have left the vehicle by opening and closing a door.)
Whenever the system is in its 30-sec ond passive arming count down,
the status LED will flash twice as fast as it does when the system is
armed. If the system is programmed for Passive Arming, care must
be taken to prevent the keys from being locked in the vehicle.