DirecTV HIRD-E11 - Manual (Page 11)

A FIRST LOOK AT THE DIRECTV PLUS DIGITAL SATELLITE RECEIVER
P AGE 1-3
combined with to access the INSTALLATION screen
The rear of the digital satellite receiver has numerous jacks for connection to your audio/video
entertainment system. You will also find the power cord permanently connected to the back.
Note: Model HIRD-E1 does not provide the upper row of audio and video jacks, the VCR CONTROL
or the RF REMOTE.
The
SATELLITE IN F-type jack is for connecting the cable from your satellite dish antenna to the digital
satellite receiver. Be sure that you use RG-6 cable only.
The
IN FROM ANT F-type jack is an input where you can connect the cable from an RF terrestrial
source such as an off-air antenna or cable TV service. This is not where you should connect the cable
from the satellite dish!
The
OUT TO TV F-type jack is an RF output which you may connect to your TV or VCR (depending
on your entertainment system). Note that the CH3/CH4 switch on the upper left enables you to select
the channel for your TV on which the DIRECTV PLUS System programming appears.
The phono-type AUDIO output jacks, labeled and color coded (
L is white, R is red) to indicate left and
right, can be used for connection to your TV, VCR, or audio system. The phono-type composite
VIDEO output jack is color-coded yellow. You may use this jack for connection to your TV or VCR.
The multiple-pin
S-VIDEO jack is for high-quality output of DIRECTV PLUS System video. Use this
jack to achieve the clearest picture for your TV or VCR. Only newer high-end TVs, SVHS VCRs and
Hi8 VCRs support S-video connections.
The standard RJ-11 modular
PHONE JACK is for connecting the digital satellite receiver to your
phone line. This phone connection is necessary to access certain program offerings from DIRECTV.
Any calls generated by the digital satellite receiver are toll free. The telephone line connection will not
normally interfere with your telephone operation. The digital satellite receiver will, however, call a
toll-free number briefly to report any purchased pay per view programs.
The
VCR CONTROL mini-jack, found only on model HIRD-E2 receivers, is for connecting the VCR
control cable included with the system. With this cable, the digital satellite receiver can interface with
most popular brands of VCRs to record selected programs automatically.
The
RF REMOTE jack is for future accessories.
HIRD-E1
HIRD-E2
The rear of the digital satellite receiver.