Fronius Acctiva Easy User Manual

Page 26

Establishing con-
nection to bat-
tery/
disconnecting

Establish a connection as follows:

Unplug the charger from the mains
Plug charger lead into charger socket
Connect (+) charging terminal to positive pole (red) on battery
Connect (-) charging terminal to negative pole (black) on the battery, or to vehicle body
(e.g. engine block) in the case of vehicle power supplies.

If using an on-board or system plug to connect the charger lead, steps 3 and 4 do not apply.
Instead, connect charger cable to a suitable on-board socket.

Acctiva Easy 1202, 1204, 1206, 2403
Charging characteristic setting:
Setting A: For charging all lead acid starter batteries
Setting B: Always charge using setting B for stationary batteries
in standby applications (e.g.: emergency power systems) or in
ambient temperatures exceeding 35 °C!
Selectiva 1006, 2003
Charging characteristic setting:
Setting A: For charging all lead acid traction batteries
Setting B: Always charge using setting B for stationary batteries
in standby applications (e.g.: emergency power systems) or in
ambient temperatures exceeding 35 °C!

NOTE! Setting the selector switch incorrectly can result in the following:
-

Charger displays incorrect test results

Charger switches to "error"

Battery will not be fully charged

Vehicle power supply will be damaged (e.g. in back-up mode)

IMPORTANT! It is not permitted to use this charger to charge dry batteries (primary cells).

ACCTIVA EASY 1206

110-230V / 50-60Hz 48W

12V = 2,5 - 4Aarith

Out:

Art. Nr.:
In:

Chr. Nr.:

Always stop charging before you disconnect the charging cable!
Toujours arrêter la charge avant de débrancher le câble de charge!

00007432420000

4,010,XXX,XXX

00000000000000

SELECTIVA 1006