Dacor MILLENNIA ETT304-1 - Manual (Page 7)

5
Models ETT304-1 and ETT365-2
NOTE: See page 6 for models MET304 and METB365-1.
IMPORTANT: When power to the cooktop is turned on after being
interrupted, the cooktop controls take a few seconds to come on.
For safety, the cooktop controls come on in locked mode. See
Locking and Unlocking the Cooktop Controls to unlock the
controls.
Each element has it’s own • ON/OFF key. The
shaded part of the diagram on each ON/OFF key
indicates the element it controls.
To turn an element on, press lightly on the
•
ON/OFF key for the desired element, then press either the
UP (▲) or DOWN (▼) heat level control key. The element
will come on at a setting of “5” as indicated by the lights
above the numbers. Press the UP (▲) or DOWN (▼) key
repeatedly to change the heat level.
To activate the outer element on the dual element, first
•
activate the inner element. Press the ON/OFF key for the left
front element and the UP (▲) or DOWN (▼) key. Activate the
outer element by pressing the outer element key (the circle)
on the right side of the element control. Adjust the heat level
for the dual element with the UP (▲) and DOWN (▼) keys.
The outer heating element cannot be operated alone.
ETT304-1 Cooktop Controls ETT365-2 Cooktop Controls
10
8
7
6
5
4
ON/OFF
ON/OFF
ON/OFF
ON/OFF
9
1
2
3
10
8
7
6
5
4
9
1
2
3
10
8
7
6
5
4
9
1
2
3
10
8
7
6
5
4
9
1
2
3
10
8
7
6
5
4
ON/OFF
9
1
2
3
10
8
7
6
5
4
9
1
2
3
10
8
7
6
5
4
9
1
2
3
10
8
7
6
5
4
9
1
2
3
10
8
7
6
5
4
9
1
2
3
ON/OFF
ON/OFF
ON/OFF
ON/OFF
Left front
element outer
element key
Left front
element outer
element key
Heat level
control keys
Heat level
control keys
Residual heat
indicator lights
Residual heat
indicator lights
ON/OFF keys ON/OFF keys
Dacor
logo key
Dacor
logo key
Before Using the Cooktop...
Clean the cooktop thoroughly before operating it for the first •
time, according to the Care and Cleaning section.
During the first uses of the cooktop, you may smell a slight
•
burning odor or see light smoke. These conditions are normal
for new glass ceramic cooktops.
Be certain that the cookware and glass surfaces are clean
•
and dry before you turn on an element and place a pot or pan
on the cooktop.
10
8
7
6
5
4
ON/OFF
ON/OFF
ON/OFF
ON/OFF
9
1
2
3
10
8
7
6
5
4
9
1
2
3
10
8
7
6
5
4
9
1
2
3
10
8
7
6
5
4
9
1
2
3
Cooktop Operation
Selecting the Proper Cookware
Utensils will affect the overall safety and performance of cooktop
cooking, so it is important to select them carefully. An improperly
selected utensil will not cook efficiently or evenly.
For best results: use medium to heavy-gauge metal cookware
with flat and smooth bottoms for greatest efficiency. Also choose
cookware that closely matches the diameter of the element. Use
utensils with tight fitting lids to retain heat, odors and steam.
Operating the Element Controls
To turn an element off, press the • ON/OFF key for the that
element. To turn off all elements at once press the Dacor
logo key at the bottom of the cooktop controls rapidly two
times. The residual heat indicator lights will remain lit until the
corresponding elements are safe to touch.
locking and Unlocking the Cooktop Controls
To avoid accidentally turning on an element or to make it more
difficult for children to operate, activate the cooktop lock feature.
To make the cooktop controls non-operational, press and •
hold the Dacor logo key for approximately three seconds.
The cooktop will beep three times and the element keys will
stop working. The light behind the Dacor logo will come on
indicating that the controls are locked.
To re-activate the controls, push and hold the Dacor logo
•
key again for three seconds. Three beeps will sound and the
Dacor logo light will go out when the controls are unlocked.