Foxconn NF4SLI7AA-8EKRS2 - Manual (Page 23)

16
Chapter 2 Installation Instructions
Hard Disk LED Connector (IDE_LED)
Attach the connector to the IDE_LED on the front panel of the case; the LED will
flash while the HDD is in operation.
Reset Switch (RESET)
Attach the connector to the Reset switch on the front panel of the case; the
system will restart when the switch is pressed.
Power LED Connector (PLED)
Attach the connector to the Power LED on the front panel of the case. The Power
LED indicates the power supply status. When the system is in S0 status, the
LED is on. When the system is in S1 status, the LED is blink. When the system
is in S3 status, the LED is off.
Power Switch Connector (PWRBTN#)
Attach the connector to the power button of the case. Pushing this switch allows
the system to be turned on and off rather than using the power supply button.
Front Panel Connector: FP1
This motherboard includes one connector for
connecting the front panel switch and LED
indicator.
1
2
NC HDD_LED RESET
PLED PW RBTN#
- +
9
10
F FP1 !
Empty
- +
PDF 文件使用 "pdfFactory" 试用版本创建 Æ Æ www.fineprint.com.cn