Foxconn NF4SLI7AA-8EKRS2 User Manual

Page 22

Chapter 2 Installation Instructions

This motherboard includes connectors for FDD devices, IDE devices, SATA
devices, USB devices, 1394b devices, IR module, CPU fan, system fan, and
others.

Other Connectors

FDD connector: FLOPPY

This motherboard includes a standard FLOPPY interface, supporting 360 K, 720 K,
1.2 M, 1.44 M, and 2.88 M FDDs.

IDE Connectors: PIDE & SIDE

These connectors support the Ultra ATA 100/66/ 33 IDE hard disk ribbon cable.
Connect the cable’s blue connector to the primary (recommended) or second-
ary IDE connector, then connect the gray connector to the slave device (hard
disk drive) and the black connector to the master device. If you install two hard
disks, you must configure the second drive as a slave device by setting its
jumper accordingly. Refer to the hard disk documentation for the jumper settings.

Attention:

Ribbon cables are directional, therefore, make sure to always con-
nect with the cable on the same side as pin 1 of the PIDE/SIDE or
FLOPPY connector on the motherboard.

PDF 文件使用 "pdfFactory" 试用版本创建