Foxconn D180S - Manual (Page 18)

HARDWARE INSTALLATION
11
front Panel Header : fP1
This motherboard includes one header for
connecting the front panel switch and LED
Indicators.
Hard Disk LeD Connector (HDD-LeD)
Connect to the chassis front panel IDE
indicator LED. It indicates the active status
of the hard disks. This 2-pin connector is
directional with +/- sign.
Reset Switch (ReSeT-SW)
Attach the connector to the Reset switch on
the front panel of the case; the system will
restart when the switch is pressed.
Power LeD Connector (PWR-LeD)
Connect to the power LED indicator on the
front panel of the chassis. The Power LED
indicates the system’s status. When the
system is in operation (S0 status), the LED
is on. When the system gets into sleep mode
(S1) , the LED is blinking; When the system
is in S3/S4 sleep state or power off mode
(S5), the LED is off. This 2-pin connector is
directional with +/- sign.
Power Switch Connector (PWR-SW)
Connect to the power button on the front
panel of the chassis. Push this switch allows
the system to be turned on and off rather than
using the power supply button.
LPT Hearder : LPT
The header supports parallel port which can be
connected to a printer or a scanner. System usu-
ally assign IRQ7 as it’s default interrupt request
and the parallel port has three operation mode:
[SPP], [EPP], [ECP].
HDD-LED
RESET-SW
NC
+
-
PWR-SW
+
-
PWR-LED
EMPTY
1 2
10 9
FP1
Strobe Auto Feed
1 2
25 26
Error
SLCT IN
INIT
Ground
Ground
Ground
Ground
Ground
Ground
Ground
Ground
Empty
Data it [0]
Data it [1]
Data it [2]
Data it [3]
Data it [4]
Data it [6]
Data it [5]
Data it [7]
ACK
Busy
Paper End
Select
LPT