Foxconn K8M890M2MA-KRS2H User Manual
Page 32
Chapter 3 BIOS Description
25
v
First/Second/Third Boot Device
This option allows you to set the boot device’s sequence.
v
Boot From Other Device
With this function set to enable, the system will boot from some other de-
vices if the first/second/third boot devices failed. The setting values are: Dis-
abled and Enabled.
v
Swap Floppy Drive
This option is used to set Swap Floppy Drive.
v
Boot Up Floppy Seek
This option is used to enable or disable the tests floppy drivers to determine
whether they have 40 or 80 tracks.
v
Boot Up NumLock Status
This option defines if the keyboard Num Lock key is active when your system
is started. The setting values are: On and Off.
v
Typematic Rate Setting
If this option is enabled, you can use the following two items to see the
typematic rate and the typematic delay settings for your keyboard. The avail-
able setting values are: Disabled and Enabled.
v
Typematic Rate (Chars/Sec)
Use this option to define how many characters per second a held-down
key generated.
v
Typematic Delay (Msec)
Use this option to define how many milliseconds must elapse before a held-
down key beings generating repeat characters.
v
Security Option
When it is set to “Setup”, a password is required to enter the CMOS Setup
screen; When it is set to “System”, a password is required not only to enter
CMOS Setup, but also to start up your PC.
v
MPS Version Control For OS
This option is used to set up the version of MPS Table used in NT4.0 OS.
PDF 文件使用 "pdfFactory" 试用版本创建