Foxconn K8M890M2MA-KRS2H User Manual
Page 17
Chapter 2 Installation Instructions
10
Other Connectors
This motherboard includes connectors for FDD devices, IDE devices, Serial ATA
devices, USB devices, IR module, and others.
FDD Connector: FLOPPY
This motherboard includes a standard FDD connector, supporting 360K, 720K,
1.2M, 1.44M, and 2.88M FDDs.
HDD Connectors: PIDE & SIDE
This connectors supports the provided Ultra DMA 133/100/66/33 IDE hard
d isk ribbon cable. Connect the cable’s blue connector to the primary
(recommended) or secondary IDE connector, then connect the gray connector
to the Ultra DMA 133/100/66/33 slave device (hard disk drive) and the black
connector to the Ultra DMA 133/100/66 master device. If you install two hard
disks, you must configure the second drive as a slave device by setting its jumper
accordingly. Refer to the hard disk documentation for the jumper settings.
Attention:
Ribbon cables are directional, therefore, make sure to
always connect with the cable on the same side as pin 1 of the
PIDE/SIDE or FDD connector on the motherboard.
PDF 文件使用 "pdfFactory" 试用版本创建