Foxconn NF3GK8MA-RS - Manual (Page 64)

Chapter 5 NVIDIA RAID Introduction
2. Press Y if you want to wipe out all the data from the RAID array, otherwise press
N . You must choose Yes if the drives were previously used as RAID drives.
The Array List window appears, where you can review the RAID arrays that you
have set up.
3. Use the arrow keys to select the array that you want to set up, then press Enter.
The Array Detail window appears.
4. If you want to mark this disk as empty and wipe out all its contents then press C .
5. At the prompt, press Y to wipe out all the data, otherwise press N .
6. Press Enter again to go back to the previous window and then press Ctrl+X to exit
the RAID setup.
ＮＦ３ＵＫ８ＭＡ－ＮＦ３ＧＫ８ＭＡ－ｍａｎｕａｌ－Ｖ１．１．ｐ６５ 2005-3-16, 17:34 56