Foxconn NF3GK8MA-RS - Manual (Page 30)

Chapter 2 Installation Instructions
BIOS TBL Jumper: TBL_EN
The system cannot boot, if flash the BIOS fail in
conventional flash BIOS process. You will no such
worry when you use the BIOS TBL function. It is
used to protect BIOS “Top Boot Block”. The system
still can boot by using this function and show some
information to recover the BIOS even if flash BIOS
fail. To utilize this function, you just leave this jumper
as default(pin 2 and 3 together with the jumper
cap).
BIOS TBL
Disable
1
2
3
BIOS TBL
Enable
(Default)
1
2
3
Note: Before you flash the BIOS, you’d better note down the MAC address, for
the MAC address maybe lose by incorrect flash operation.
You can get the MAC address from a label on the Parallel Port on the
motherboard.
For example:
After you note down the MAC address, you can reference the following process
to key in the MAC address:
1. Boot your computer, press Del to enter the BIOS Setup.
2. Select the Integrated Peripherals. Then Press Enter.
3. Enabled the Machine MAC(NV) Address.
4. Select MAC(NV) Address Input, then press Enter.
5. Input the MAC address to the open table.
For advanced user, you can modify the MAC address by the AW ARD BIOS
Flash Tool.
EA=XXXXXXXXXXXX
Boot mode select Jumper: J3B2
The jumper is used to select between a user table
and a safe table for boot initialization parameters.
Please keep it as default setting.
User Mode
1
2
3
Safe Mode
(Default)
1
2
3
ＮＦ３ＵＫ８ＭＡ－ＮＦ３ＧＫ８ＭＡ－ｍａｎｕａｌ－Ｖ１．１．ｐ６５ 2005-3-16, 17:21 22