Foxconn NF3GK8MA-RS - Manual (Page 26)

Chapter 2 Installation Instructions
Fan Connectors: CPU_FAN, FAN_1 (optional), FAN_2
There are three fan connectors on this motherboard.
Audio Connectors: CD_IN, AUX_IN (optional)
CD_IN, AUX_IN is Sony standard CD audio
connectors, to receive audio input from the CD-ROM,
attach its audio connector to the CD_IN/AUX_IN au-
dio connectors on the motherboard.
1 1 1
The Serial ATA connectors are used to connect
the S-ATA devices to the motherboard. These
connectors support the thin Serial ATA cables
for primary internal storage devices. The cur-
rent S-ATA interface allows up to 150MB/s data
transfer rate.
S-ATA Connectors (optional): SATA_1, S ATA_2
The audio port includes two parts – the Front
Audio and Rear Audio. Their priority is se-
quenced from high to low (Front Audio to Rear
Audio). If headphones are plugged into the front
panel of the chassis (using the Front Audio),
then the Line Out (Rear Audio) on the rear panel
will not work. If you do not want to use the Front
Audio, pin 5 and 6, pin 9 and 10 must be short,
and then the signal will be sent to the rear au-
dio port.
Front Audio Connector: F_AUDIO
ＮＦ３ＵＫ８ＭＡ－ＮＦ３ＧＫ８ＭＡ－ｍａｎｕａｌ－Ｖ１．１．ｐ６５ 2005-3-16, 17:21 18