Foxconn 760GXK8MC - Manual (Page 22)

16
Chapter 2 Installation Instructions
S/PDIF Out Connector: SPDIF_OUT
The S/PDIF out connector is capable of pro-
viding digital audio to external speakers or
compressed AC3 data to an external Dolby
digital decoder.
Note: The empty pin of SPDIF cable should
be aligned to empty pin of SPDIF out
connector.
5V
GND
Empty
DATA
1
Audio Interface: F_AUDIO
The audio interface provides two kinds of
audio output choices: the Front Audio, the
Rear Audio. Their priority is sequenced from
high to low (Front Audio to Rear Audio). If head-
phones are plugged into the front panel of
the chassis (using the Front Audio), then the
Line-out (Rear Audio) on the rear panel will
not work. If you do not want to use the Front
Audio, pin 5 and 6, pin 9 and 10 must be
short, and then the signal will be sent to the
rear audio port.
Speaker Connector: SPK
The speaker connector is used to connect
speaker of the chassis.
SPEAKER
SPK
SPKJ
Emypty
NC
1
COM2 Connector: COM2
This board provides an additional serial
COM connector for your computer. You
need connect the switching-cable to this
connector first, and then connect the serial
COM device with the port of the switching-
cable.
COM2
DSR#
DCD# RI# GND
RTS# TXD
EMPTY
DTR# CTS#
1
2
9
10
RXD
F_AUDIO
MIC_GND MIC
+5VAC MIC_PWR
AUT_RET_R AUD_OUT_R
EMPTY
AUD_OUT_L AUT_RET_L
1 2
9 10
NC