Formax Cut-True 27S - Manual (Page 6)

DESCRIPTION OF EQUIPMENT PARTS
OVERVIEW
1. Cover Attached to the cutter with four screws. Disassemble only in case of blade
change or maintenance.
2. Enable Switches These switches must be pushed simultaneously to operate the paper clamp
and cutting blade.
3. Power Switch Used to turn on and off power to the cutter.
4. Back Gauge Crank Used to adjust back gauge to appropriate paper size and cut length. It is
indirectly connected with the Back Gauge: to engage the crank, simply
push it towards the machine, then turn. To release, pull the crank toward the
operator.
To move the back gauge toward the operator, turn clockwise.
To move the back gauge away from the operator, turn counterclockwise.
5. Power Light Shows when machine is powered on.
6. Key-Activated Mode Select Switch Turn to right for cutting. Turn to left for blade replacement. Turn to middle to
stop all operations.
7. Digital Measurement Readout Shows the current position of the back gauge, in mm and inches.
8. Rear Safety Cover Clear plexi cover is provided for operator safety and helps to prevent dust
buildup.
9. Front Safety Cover Prevents operators from placing hands or other objects in the cutting area.
Must be in the lowered/closed position in order to operate the cutter. The
guard can only be reopened when the blade is in the upright position.
10. Side Interlock Device A The cutter will not operate if the 6mm T-wrench used for blade adjustments
is still in the adjustment slot.
11. Side Panel Additional workspace.
12. Carrier (support) Carries the blade holder and the entire mechanism of the machine.
13. Safety Interlock Device B The machine can only be operated when the safety guard is closed.
14. Three Socket Headless Screws Adjustable screws for even cutting.
15. Cutting Blade Made of high-quality carbon steel.
3
1
24
19
13
12
10
9
8
7
2
6
5
4
3
2
18
17
16
15
14
10
23
22
21
11
20