Formax Cut-True 27S - Manual (Page 11)

9. Grip and loosen both of the blade change tool
handles by turning just a half reverse turn to
remove the blade from the machine. Carefully
move the blade and holder downward in order
to remove it safely from the machine. NOTE: Be
careful to avoid injury from the very sharp blade.
8. Remove the center screw.
Blade change safety tool in place
10. Carefully remove the old blade from the blade
change safety tool. Set it on a flat surface and
unscrew the handles. Cap the old blade with a
protective pad to prevent injury.
11. Place the new blade with the beveled cutting
edge facing up, and the screw holes at the top,
as shown here. Remove the protective pad
from the new blade.
To attach the blade change tool, place it over
the blade and screw the handles into the lower
set of screw holes. Then reverse the procedure
to install the new blade. Beveled cutting edge
8