Formax Cut-True 15M - Manual (Page 5)

ASSEMBLY
The handgrip of the blade lever arm, the spindle guided clamp wheel and the back gauge crank with screw are packed
separately in the box with the machine. Install these parts first.
The chassis and stand of the machine should be connected as follows:
1. Set the legs so the 4 threaded pins point upward.
2. Assemble the crossbars of the stand so the color labels on each match the corresponding legs.
3. Place the chassis correctly onto the assembled stand.
NOTE: When attaching the cutter to the chassis, the screw on the top of each leg must accurately aim at the
triangle holes on the corners of the underside of the cutter. These must be affixed properly to keep the machine
table from collapsing.
4. Fit the supplied washer over each of the threaded pins on the legs and tighten the hexagonal nut using a 13mm
wrench.
Battery installation/replacement:
Fit two D batteries into the battery holder on the underside of the chassis.
When the LED cutting light eventually becomes dim, replace the batteries with fresh ones.
2