Formax FD 670 - Manual (Page 17)

13
VERTICAL FOLDER
SET-UP
FUNCTION
Vertical folder provides means for folding two-wide
forms side-to-side prior to their entry into burster.
SET-UP PROCEDURE
1. Place forms on floor at infeed end of burster.
2. Thread forms through folding bale. (Fig. 13) If you
are going to imprint, arrange forms so that side to be
imprinted is facing down.
3. Folding bale should line up with infeed guides so
edge of the form is in a straight line. (Fig. 13)
4. Position the infeed brush to the side of the forms
opposite tractor being used. (Fig. 13)
5. Center perforation of forms in a straight line from
floor to infeed brush.