Formax FD 540 User Manual

Page 10

10. If necessary, readjust the position of the Feed

Roller Carriage so that the form starts to burst when the

perforation is just under the Tear Bar.

NOTE: The Tear Points can be moved to allow the operator to

position them at any location along the Tear Bar. The

Tear Points should be set between the perforations

that run the length of the form. (Fig. 11)The Tear Bar

height is adjustable to accommodate the characteristics

of various forms. To adjust the height, the tear bar must

be pushed to compress the spring and lifted out. Then

rotate 180 degrees (turned over) and replace making

sure that the square end of the bar locks in the

brackets. Lower position is normal operation, #2313-up.

(Fig. 12)

11. Close safety cover. Machine is now ready to Burst.

Press start button and readjust machine speed to the

fastest, yet smoothest Burst.