Formax FD 8904B - Manual (Page 21)

BALEr OiL LEVEL / VENTiNG LiD
1. Move the press ram into its rear end position.
2. Switch the main switch off.
3. Unscrew the rear cover and the venting lid.
4. Check the oil level on the oil dipstick of the venting lid. The oil level must be between the two notches on
the oil dipstick.
5. If the oil level is below the bottom notch, replenish oil via the opening for the venting lid (Figure 4).
Maintenance interval: Replace venting filter every 2 years.
6. Screw the venting lid back on again.
7. Screw the rear cover back on again.
Remove rear cover to access
oil basin.
18
Fig. 1