Formax 6202 Series - Manual (Page 8)

9
ENGLIS
H
3.5 Other job
Select the desired job in the "Other job" menu.
Confirm the job selection with "OK" which will
get you back to the "main menu (1)".
3.6 Main menu (2)
Main menu (2) shows the following functions
(see figure below):
• reset count,
• insert position,
• job menu.
3.7 Reset count menu
After pressing key 1 in "main menu (2)", the
counter is set to zero.
3.8 Adjustments for document
feeding
Document separation
The document separation for the feeders is set
automatically.
Side guides
To adjust the side guides it is best to remove the
document feeding tray as follows (see figure
below):
• push handle A downwards,
• lift the document feeding tray upwards to
unhook it and then pull it out from the feeder,
• loosen knob B half a turn (see figure below),
• grab the side guides C in the middle and push
them outwards,
• put a small stack of documents between the
side guides,
• grab the side guides in the middle and push
them towards the documents,
• The space between the side guides and the
documents should be such that the
documents have just enough play to move
freely,
• re-tighten knob B,
• remove the stack of documents.
Replace the document feeding tray as follows
(see figure below):
• place the document feeding tray under guide
A,
A
C C B