Formax 6202 Series - Manual (Page 23)

24
7.4 OMR error codes
error description suggested solution information Error code
Reading error. Remove the documents and
adjust the 1st mark from the
top position correctly. Wrong window position. 3 : 112
Reading error. Remove the current
suspected set and check the
next set. Suspected set after error. 3 : 114
Reading error. Remove the documents and
adjust the reading head.
Adjust the1st mark from the
top position correctly. When
the error still occurs, contact
your service organization. Not enough marks. 3 : 120
Reading error. Remove the documents and
check the used OMR code. No basic command. 3 : 122
Reading error. Remove the documents and
check the used OMR code.
Adjust the reading head. Wrong parity in code. 3 : 126
Reading error. Remove the documents and
check the used OMR code
(flex-dongle). Undefined mark found 3 : 127
Reading error. Remove the documents and
check the used OMR code’s
(mark line distance). Wrong mark distance. 3 : 128
Reading error. Remove the documents and
check the used OMR code
(flex-dongle). Too many marks. 3 : 129
Too many sheets. Remove the documents.
Check the set and complete
the set manually. Set size exceeded. 3 : 134
Incomplete set. Remove the documents.
Check the set and complete
the set manually. Part of previous set. 3 : 135
Service assistance is needed for the error codes with the message “technical failure”. First write down
the error code, then switch the inserter off and on again, to verify system operation. When the error still
occurs contact your service organization.