Fluke Biomedical 190I - Manual (Page 18)

Victoreen 1901
Operators Manual
2-2
If the detector has not been initialized and
calibrated (either at the factory or via the optional
infrared communicator), the CPM and CPS modes
are the only modes available.
All but one of the Operational Modes may be disabled via the 190I-1A Communicator; one default mode
must be enabled for the instrument to operate properly.
2.2 Changing the Display Mode (Rate/Integ)
The front panel Rate/lnteg button toggles the alphanumeric display between the digitized rate value and
the integrate value. Press Rate/Integ to automatically change the display mode.
The Rate/lnteg button may be disabled (and the display mode fixed) via the optional 190I-1A
communicator.
2.3 Logging Displayed Data (Log)
If the Data logging function is selected to be operational (via the optional Communicator), currently
displayed data will be stored for future retrieval. The procedure for logging data depends on the Log
Mode (Manual or Timed, with or without location identifiers, as selected via the communicator).
The Log Mode is always inactive when the unit is
turned on and data logging can only be activated
through the optional Communicator. If the Log Mode
has not been activated, a NOT IN LOG MODE
message will be displayed when the Log button is
pressed. When in the data logging mode, the
instrument ON/OFF button is in active and the
instrument will stay on until the data has been
retrieved. Refer to the 190003 Instruction Manual
provided with the 190-1A Communicator and
94190C00-200 software for further information and
instructions.
In the manual mode, displayed data is logged by pressing the front panel Log button. The following
message will appear in the alphanumeric display:
Data logging in manual mode. ready
In the timed mode, data is logged at specific intervals. The following message will appear in the
alphanumeric display:
Data logging in timed mode. ready
NOTE
NOTE