Fluke Biomedical ESA620 - Manual (Page 30)

ESA620
Users Manual
16
Setting Polarity Switching Delay
When switching the polarity of the Analyzer’s test
receptacle, a delay can be set to control the actual switch
time. To set the polarity delay:
1. Press the softkey labeled Instrument from the setup
menu to reveal the instrument setup selections.
2. Press the softkey labeled Polarity Delay to open the
scroll box above the softkey label.
3. Press  or  to adjust the delay from 0 to 5
seconds in 1 second steps.
4. Press the softkey Back then the softkey labeled Exit
to exit the setup function.
Setting the Display Contrast
There are two methods for setting the display contrast.
From the “Select a Test….” menu or through the setup
menu.
Whenever the Analyzer displays its start-up menu (Select
a test…), pressing  or  will increase or decrease the
display’s contrast respectively. Press the softkey labeled
Done to exit contrast setup.
Another way to adjust the contrast is through the
Analyzer’s setup menu.
1. Press the softkey labeled Display from the setup
menu.
2. Press the softkey labeled Contrast.
3. Press  or  to increase or decrease the display’s
contrast respectively.
4. Press the softkey labeled Done to exit contrast
setup.
Setting up the Beeper
In addition to being enabled or disabled, the Analyzer’s
beeper volume can be set as well. To setup the beeper:
1. Press the softkey labeled Sound from the setup
menu.
2. Press the softkey labeled Beeper to switch the
beeper on and off.
3. Press the softkey labeled Volume to open a scroll
box above the softkey label.
4. Press  or  to increase or decrease the volume
respectively.
5. Press the softkey labeled Done to go back to the
setup menu.