Flowserve DRC-17 - Manual (Page 16)

16 DataFlo Digital Electronic Remote Controller DRC17 WCAIM2058
Alarm conditions may be cleared by pressing the ENT key.
However, if the condition that caused the alarm is still
present after the ENT key is pressed, the alarm will re-
appear and will not be cleared. While any alarm condition
is present, the Alarm LED on the DRC circuit card will
also be activated.
4.6 Program Mode
The Program Mode of operation is used to examine and change
parameter values. Instructions are given in this section for using
this mode. Table 2 shows all programmable parameters, their
display name, and data range.
4.6.1 Entering the Program Mode
1. In the Run Mode, press either the key or the key
until the mode display appears.
2. Press ENT to edit the value. It will start blinking the
current mode.
3. Press either or until PROG is visible.
4. With PROG blinking, press the ENT key to change to
the Program Mode.
4.6.2 Examining and Changing Parameter Values
1. Press either the or key until the parameter name
appears on the display. It will alternate with its value.
2. Examine the value as it alternates with the parameter
name.
3. To change the value, press the ENT key and the value
will begin blinking.
4. Press the or keys to increase or decrease the
value respectively. If the variable has selections made
from a list, pressing the keys will access each item in
the list. If the variable has both list and numeric
possibilities, the list choices will be shown when the
maximum numeric value is reached and
is pressed
or when the lowest numeric value is reached and
is pressed.
5. To save a new value, press the ENT key. The
parameter name will then alternate with its new value.
6. To not use the new value, press the key to abort
editing. The parameter name will then alternate with
its original value.
Flow Control
Worcester Actuation Systems