Flowserve 3400IQ - Manual (Page 12)

Logix 3400IQ Digital Positioner FCD LGENIM3403-00 – 11/07
Transducer Block (FVPTB)
NOTE: To view the transducer block, first click the Transducer Block icon.
The transducer block is where all configuration, calibration and diagnostics are set up, and read. Due to the
large amount of data that can be accessed in the transducer block, the custom view option should be used
and the parameters of interest selected. To do this, choose the Custom tab in the FVPTB Window and click
the Customize Parameters button on the tool bar. Check the items to view in the pop-up selection menu.
Check the Periodic Update button to have the Configurator update the data every couple of seconds.
A
B
C
A. Periodic Update Box B. Custom Parameters C. Selection Menu
Figure 9: Transducer Block Window
If the positioner is to be controlled by the AO block, the FVPTB block must be in Auto. If the positioner is to
be controlled by the FVPTB the AO block must be in OOS and FVPTB in OOS. To move the valve, write to
FINAL_VALUE: VALUE.
12