Flowserve WMV IDP - Manual (Page 25)

WMV, WMVS USER INSTRUCTIONS ENGLISH 26999970 10-12
Page 25 of 28
flowserve.com
8.2 Type WMVS
Item Part no. Description Material
1 8100 Motor -
2 3160 Motor pedastal Cast iron
3 7120 Coupling half Cast iron
- 6570.1 Screw for coupling -
4 2923 Pin Zinc plated steel
5 7450 Coupling guard Sheet steel
6 2100 Shaft 431S29 stainless steel
7 4610 O-ring Synthetic rubber
8 4200 Mechanical seal -
9 - Pre-load cone Stainless steel
10 3126 Shims Polypropylene
11 6570.2 Grub screw Stainless steel
12 2530 Retaining ring Stainless steel
13 2912 Impeller nut Stainless steel
14 - Split bush Stainless steel
15 2200 Impeller Noryl ® thermoplastic resin
15A - Impeller insert Stainless steel
16 - Stage piece Noryl ® thermoplastic resin
16A - Stage bearing Filled polymer
17 6571 Tie bolt High tensile steel
18 - Outer casing Stainless steel
19 - Stage piece adaptor Stainless steel
20 6230 Balance drum Stainless steel
21 6231
Balance drum
bearing
Filled polymer
22 6569.1 Drain/gauge plug Stainless steel
23 6569.2 Drain/gauge plug Stainless steel
24 1100 Casing Stainless steel
25 6523
Filling/vent air
release plug
-
26 - Seal chamber plug -
27 - Retaining ring Stainless steel
28 - Seal adaptor Stainless steel
Ref. 15A and 16A are not separate components.
Noryl ® is a registered trademark of General Electric Plastics BV.
8.3 General arrangement drawing
The typical general arrangement drawing and any
specific drawings required by the contract will be sent
to the Purchaser separately unless the contract
specifically calls for these to be included into the User
Instructions. If required, copies of other drawings
sent separately to the Purchaser should be obtained
from the Purchaser and retained with these User
Instructions.