beautypg.com

Cause – Floscan 9000-20B-1 GPS Interface System User Manual

Page 25

background image



8/30/2004

7000-044-00D

FloScan Instrument Company, Inc.

Tel: (206) 524-6625 Fax: (206) 523-4961

3016 NE Blakeley Street, Seattle, WA 98105 Email: [email protected] Http://www.floscan.com

XII. NMEA 0183 Input, MPG, (Nautical) Miles per Gallon Problems:

Error Codes

Display Reason

Cause

OFF

No signal activity present on NMEA 0183 terminals

for four seconds

GPS / LORAN-C OFF
NMEA OUTPUT not selected
Leads not connected
A & B leads reversed

- - -

Receiving valid NMEA 0183 Version 1.5 or 2.0

message, speed message invalid.

GPS satellite reception is poor
GPS / LORAN-C in startup mode

- 0 -

Fuel flow reading below 0.1 GPH (LPH) (twin-both

engines). Valid NMEA 0183 speed message
present.

Engine(s) not running
Fuel flow reading problem.

Er1

Some pulsing activity present. No valid NMEA

0183 message received in last four seconds.

Leads connected to wrong source
GPS / LORAN-C set to NMEA 0180 or 0182
A & B leads reversed.

Er2

NMEA message detected. Missing “GPRMC” or

“LCRMA” sentence.

GPS / LORAN-C incompatible with NMEA 0183,

ver. 1.5 or newer

1.

An OFF display in the GPH/MPG window indicates the FloScan Instrument isn’t receiving a NMEA 0183 speed signal from

the GPS. Check wiring connections to the GPS, and verify that it is turned on.

2.

A Dash, Dash, Dash, (- - -) display indicates the GPS is in startup mode, or satellite reception is poor.

3.

A Dash 0 Dash, (- 0 -) display indicates a valid NMEA 0183 speed message is present, but that fuel flow readings are so low

the FloScan Instrument is unable to compute a meaningful MPG figure. Dash 0 Dash, (- 0 -) may be displayed when motoring at
low speeds, or when slowing down. When slowing down the FloScan Instrument may display ever-increasing MPG readings, go
to Dash 0 Dash, (- 0 -) and start redisplaying ever-increasing readings again.

4.

Er1 indicates that the FloScan Instrument isn’t receiving a valid NMEA 0183 message from the GPS. Check wiring

connections to the GPS.

5.

Er2 indicates that, “GPRMC” or “LCRMA” is missing from the GPS NMEA 0183-speed signal message. Verify the GPS

sending a NMEA 0183 version 1.5 or newer signal.

This concludes system testing. If problems with your system persist,

contact FloScan Technical Support with testing results












This manual is related to the following products: