Fire Magic Combustible Overhead Protection Kit - Manual (Page 2)

2 REV 0 - 1502191200 L-C2-468
PROTECTION KIT ASSEMBLY (if applicable)
The 36-COPK protection kit comes fully-assembled and is
ready to install. All other protection kits require the following
assembly:
1. Orient and align the 5 holes on each panel as shown
in Fig. 2-1. Using a Philips screwdriver and an 11 / 32 "
wrench, fasten the panels together with the supplied
bolts, lock washers, and nuts.
INSTALLATION
All additional installation requirements, safety
guidelines, and any other requirements found in your
grill owner's manual MUST BE FOLLOWED.
Note: Fully covering the area above the protection kit is
recommended to prevent any water build-up from
rain.
1. Ensure the protection kit is centered over the grill (from
left to right) and the rear of the protection kit is resting
against the rear wall (see Fig. 2-2). Mark your overhead
construction as needed.
2. Using proper mounting hardware (not included), secure
the protection kit into the overhead construction.
Important: If any combustible material is used to support
and/or cover the protection kit, there must
be a 6' clearance between the combustible
construction and the countertop. See the
CLEARANCE REQUIREMENTS section on
the front of this instruction.
Fig. 2-2 Protection kit installation
(Echelon Diamond
grill shown)
Use proper
mounting hardware
(not included)
Fig. 2-1 Protection kit assembly
Overhead
construction
Any support and/or covering
(if applicable)
Protection kit
REST
AGAINST
REAR
WALL
Non-
combustible
rear wall
(60-COPK protection kit shown)