Fire Magic Aurora Multi-Housing Built-In Grill A430i-1E1(N,P)-01 - Manual (Page 6)

6
1. The outdoor grill and surrounding area MUST
remain clear of fl ammable substances such as
gasoline, yard debris, wood, etc.
2. The airfl ow through the vent space located below
the control panel must remain unobstructed.
3. When using propane gas:
a. The required ventilation openings in the
enclosure must be clear of debris.
b. The propane cylinder, regulator, and rubber
hose must be in a location not subject to
temperature above 125° F (51° C).
4. The fl ames on each burner burn evenly along
the entire burner with a steady fl ame (mostly
blue). If burner fl ames are not normal, check
and clean the orifi ce and burner/venturi tubes
for insects and insect nests. A clogged tube can
lead to a fi re beneath the grill. A proper fl ame
pattern will ensure safe operation and optimal
performance. Adjust the air shutter as needed
(see AIR SHUTTER ADJUSTMENT).
5. The in-line gas valve or gas cylinder valve must
always be shut OFF when the grill is not in use.
6. The drip collector holes must be clear and
unobstructed. Excessive grease deposits can result
in a grease fi re.
MODEL SPECIFICATIONS
GRILL MAINTENANCE AND SAFETY INFORMATION
WARNING: NEVER cover the entire cooking or grill surface with griddles or pans. Overheating will occur, and
burners will not perform properly when combustion heat is trapped below the cooking surface.
CAUTION: NEVER spray water on a hot gas unit.
TOP VIEW
Side to side
Countertop
Lower support
Front to back
2 3 /
4
"
Control
Panel
NON-COMBUSTIBLE
CABINET CUT-OUT
DIMENSIONS
Control panel width
Countertop overhang
REV 0 - 1307081445 L-C2-414
Fire-Magic ® Model Specifi cations Table
Table 1 A430i
Countertop to unit bottom (cut-out)* 12"
Side to side (noncombustible cut-out)* 25-1/2"
Front to back (noncombustible cut-out)* 19-1/2"
Control Panel width 26-3/4"
Main burner BTU
N/P orifi ce drill size 25,000
#42/#54
Optional insulating liner model # 23130-50
*Note: If using an insulating liner, consult liner instructions for counter cut-out dimensions and installation.