Lighting (ignition) instructions, Electronic lighting, Manual lighting – Fire Magic Aurora Multi-Housing Built-In Grill A430i-1E1(N,P)-01 User Manual
Page 13: 13 shutting off the unit, When using a portable propane tank, Replacing ignitor batteries

13
SHUTTING OFF THE UNIT
To shut off the unit, depress each valve control knob 
and, and while pressing turn it clockwise to the OFF 
position.
Always close the valve from the gas supply after each 
use of the unit.
ELECTRONIC LIGHTING
Note: Electronic lighting requires an installed 9-volt
battery with a good charge.
1. Open lid(s) or remove cover(s) from burner(s) to be lit.
2. Turn all gas control knob(s) to their OFF position(s).
3. Turn on the gas at its source.
Note: DO
NOT
t u r n o n m o r e 
than one valve at 
a time for either 
e l e c t r o n i c o r 
manual lighting.
4. Depress the desired control knob for 5 seconds,
then, while pressing turn it counterclockwise to the 
HI LIGHT position. Once the burner lights, release 
the knob.
CAUTION:
If a burner does not light within fi ve (5) 
seconds of turning on the control knob, 
depress the knob and turn it to the OFF 
position. WAIT FIVE (5) MINUTES 
before repeating step 4. If you smell 
gas, follow the instructions on the cover 
of this manual. If the burners still do not 
light after several attempts, refer to the 
instructions for manual lighting.
5. Repeat step 4 for each additional burner to be lit.
WHEN USING A PORTABLE PROPANE TANK
Propane tanks are equipped with a safety shutdown 
device that may cause low or no gas pressure/fl ame 
at the burners if operating and lighting instructions 
are not followed exactly (See important note in the 
TROUBLESHOOTING section for more details.) 
MANUAL LIGHTING
CAUTION: Always wait fi ve (5) minutes for gas to
clear after any unsuccessful lighting 
attempt.
1. Follow steps 1 through 3 (left).
2. Insert either a burning long-barrel butane lighter or
a burning long-stem match through the cooking grid 
opening to the top of the lighting tube. (Fig. 13-2). 
F o r b a c k b u r n e r s , h o l d t h e f l a m e 
a g a i n s t t h e s u r fa c e o f t h e b a c k b u r n e r. 
For sideburners, hold the fl ame against the burner.
3. While holding the match or lighter fl ame at the top
of the lighting tube or next to the burner (sideburner 
and backburner only), depress the desired control 
knob and while pressing turn it counterclockwise to 
the HI LIGHT position. Remove the lighter or match 
when the burner lights, and release the control 
knob.
4. If the burner does not light, immediately depress
the knob and turn the valve to OFF. WAIT FIVE 
(5) MINUTES before repeating steps 2 through 4 
of the MANUAL LIGHTING instructions.
Read all instructions before lighting, and follow these instructions each time you light the unit.
Fig. 13-2
- Manual lighting
Lighter
Lighting
tube
Fig.
13-1
- Control knob
OFF
HI
LIGHT
LOW
T
O
TURN OFF
T
O
TURN
ON
Read setting
here
HIGH to 
LIGHT
Read setting here
(OFF position shown)
To
Turn
OFF
To
T
urn
ON
Use
HI (high) 
to light
Press 
knob in 
to turn
REPLACING IGNITOR BATTERIES
To replace the 9V battery powering the ignitors, pull out the 
battery holder located on the outside of the control panel. 
Remove the lid. Disconnect the battery from the connector 
and replace it connecting the new battery. Replace the lid 
and close the drawer (see Fig. 13-3).
Fig.
13-3
REPLACING IGNITOR BATTERIES
To replace the 9V battery powering the ignitors, pull out 
the battery holder located on the outside of the control 
panel. Remove the old battery and replace it connecting 
the new battery. Replace the drawer (see Fig. 13-3).
Fig.
13-3
2. Insert either a burning long-barrel butane lighter or
a burning long-stem match through the cooking grid 
opening to the top of the lighting tube. (Fig. 13-2).
3. While holding the match or lighter fl ame at the top
of the lighting tube, depress the desired control 
knob and while pressing turn it counterclockwise 
to the HI LIGHT position. Remove the lighter or 
match when the burner lights, and release the 
control knob.
4. If the burner does not light, immediately
depress the knob and turn the valve to OFF. 
WAIT FIVE (5) MINUTES before repeating 
steps 2 through 4 of the MANUAL LIGHTING 
instructions.
LIGHTING (IGNITION) INSTRUCTIONS
