Fire Magic Choice Post Grills C430s - Manual (Page 13)

13
PATIO MOUNT INSTALLATION (cont.)
SECURING THE PATIO MOUNT GRILL
Important: BEFORE USE, the patio mount base
must be securely fastened to a stable,
level surface to ensure the grill remains
fi xed and upright at all times.
Locate the patio mount base in the planned grill
location and mark the 4 holes. Drill the marked holes
to a
1 / 2 " diameter x 1 1 / 2 " depth. Insert the lag shields
(see PARTS LIST) into the holes, being sure that they
are fl ush with the ground.
Align the holes on the patio mount base over the lag
shields in the ground. Secure the base with the lag
screws (see PARTS LIST) using a
7 /
16
" nut driver.
CONNECT THE GAS SUPPLY
For household propane or natural gas units:
Route the fl ex connector to the gas stub.
Turn OFF the gas supply at the source. Remove the
adapter that is loosely connected to the fl ex connector.
Attach the adapter to the gas-supply stub using a pipe
compound resistant to all gasses. Tighten securely. Then
attach the open end of the fl ex connector to the adapter.
Tighten securely.
For propane cylinders:
For connecting a propane unit to a portable propane tank,
read the safety warnings and follow the instructions in the
section SAFE USE AND MAINTENANCE OF PROPANE
GAS CYLINDERS.
Important: An appropriate adapter will be required to
connect the existing fl ex connector to an
L.P. regulator/hose assembly.
LEAK TEST
Turn all burner control knobs to the OFF position. Turn the
gas supply on. Then carefully check all gas connections
for leaks with a brush and half-soap/half-water solution
before lighting. NEVER USE A MATCH OR OPEN
FLAME TO TEST FOR LEAKS.
RE-SECURE ACCESS PLATE
Carefully replace the access plate using the four screws,
ensuring all interior components are properly oriented
inside of the grill. Ensure the power supply cord (and fl ex
connector if applicable) coming out of the rear of the post
are properly situated and the plastic bushing/grommet
pieces are secure in place.
REV 0 - 1412020855 L-C2-462
Fig. 13-1 Connect gas and secure plate
SECURING THE PATIO MOUNT GRILL
Important: BEFORE USE, the patio mount base must
be securely fastened to a stable, level
surface to ensure the grill remains fi xed and
upright at all times.
Locate the patio mount base in the planned grill location
and mark the 4 holes. Drill the marked holes to a
1 /
2
"
diameter x 1 1 /
2
" depth. Insert the lag shields (see PARTS
LIST) into the holes, being sure that they are fl ush with
the ground.
Align the holes on the patio mount base over the lag
shields in the ground. Secure the base with the lag screws
(see PARTS LIST) using a
7 /
16
" nut driver.
Adapter
Flex
connector
To gas supply
(as applicable,
fl ex location
may vary)