Installation (cont.), Cd e – Fire Magic Diamond Double Searing Station 32884-1(P) User Manual

Page 13

INSTALLATION (cont.)

CONNECT TO A POWER SOURCE

CAUTION: Improperly connected wires will cause damage to

the unit and may result in property damage and/
or personal injury.

The unit comes with a 6' wire extension to retrieve power from a
separately purchased Echelon Diamond grill. Echelon Diamond
grills are equipped with power supply boxes, which can supply
power to the searing station. Alternatively; an optional power
supply box may be ordered and installed to individually power
this unit. Contact your dealer for ordering information.

To install using the wire extension:

1. Locate the power supply box inside of the island enclosure

and disconnect the power cord (See Fig. 13-2, A).

2. Disconnect the grill wire harness extension connectors

from the power supply connectors. See Fig. 13-2, (B)

3. Locate the end of the searing station wire extension that

has two molex and ground connections. Connect the
extension (plug) molex connection to the power supply
(receptacle) molex connection and ground wires (See Fig.
13-3, C).

4. Connect the extension (receptacle) molex to the grill (plug)

molex connection and ground wires (See Fig. 13-3, D).

5. Connect the opposite end of the extension to the searing

station as shown in Fig. 13-3, E (molex and ground wire
connections).

6. Reconnect the power cord (see Fig. 13-3, F).

Proceed to the SLIDE UNIT INTO ENCLOSURE section.

To install using a power supply box (not included):

1. Install the power supply box at least 12 inches below the

bottom of the searing station.

2. Fasten the power supply box to the inside of the enclosure.

3. Connect the power supply box connectors to the searing

station wire harness extension, as shown in Fig. 13-4, A
(molex and ground wire connections).

4. Connect the searing station wire harness extension to

the searing station, as shown in Fig. 13-4, B (molex and
ground wire connections).

5. Connect the cord coming from the power supply

b ox t o a 1 2 0 VAC ( 1 5 A M P m i n i mu m ) G F C I
GROUNDED 3-wire receptacle . See Fig. 13-4,
C.

WARNING: Electrical Grounding Instructions - The

power supply box is equipped with a three-
pronged (grounding) plug for your protection
against shock hazard and should be plugged
directly into a properly grounded three-
prong receptacle. Do not cut or remove the
grounding prong from this plug.

Fig. 13-2 Disconnect grill connections

Power supply

box

Grill wire

harness

extension

Fig. 13-1 Connection detail

Receptacle

Plug

REV 2 - 1502100955

L-C2-379

Fig. 13-3 Connect searing station to grill setup

Double searing

station

Searing station

wire harness extension

Fig. 13-4 Connect searing station to power supply