Fenix ECOFILM SET - Manual (Page 8)

8
DAY Setting
1. 15 °C
2. 18 °C
3.–5. 20 °C
6.–8. 25 °C
8. Start-up Operation
• The ECOFILM heating system can be started without a start-up operation in case it has not been installed
on concrete or similar construction material.
• Observe the following start-up operation when the system is installed on concrete:
• After this start-up, switch off the heating system. When it cools down, switch on a normal operation mode.
9. Control
• Thermostats with a floor probe installed in the heating part of the floor, with at least 30 cm within the
heated area, must be used for the thermal regulation of rooms heated using heating foils.
• Place a floor probe of a thermostat as near the floor surface as possible, but right under the heating foil,
into a groove, when a laminated floor is installed.
• The radius of the bend of the conduit between the wall and the floor must be executed in such a way that
the probe can be exchanged if needed! The recommended minimum bend radius is 6 cm.
• The thermostat must be set to the mode: Room + floor temperature limit or Floor. The maximum allowed
floor temperature setting is 27°C.
10. Examples of suitable materials and floors
Examples of suitable materials and floors:
• ALLOC – Havel floating floors
• MAGNUM – www.magnumparket.cz
• Laminate floors, by Egger – http://www.egger.com,
• JUNCKERS wooden floors – HEMAX Trading s.r.o., http://www.junckers.cz
• Wooden and laminate floors – ABH design, http://www.abhdesign.cz
• Wooden and laminate floors – AB Parket STUDIO, http://www.abparket.cz
• Wooden and laminate floors – APIA s.r.o., http://www.parkety.com
• Floor wholesale, installation company – TOOM, http://www.toom.cz
• Mirel – www.mirel.cz
11. Warranty, Complaints
The supplier of the ECOFILM heating film provides a warranty period of 10 years for the product’s functional-
ity, beginning from the date of its installation that is confirmed in the certificate of warranty (installation must
be made at latest within 6 months from the date of purchase), provided that:
1. The installation and the way of using must correspond to the Guide.
2. The completed and confirmed Warranty Certificate with all necessary data must be submitted.
3. The delivery note or the invoice issued at the moment when the product was bought must be submitted.
4. The product has not been damaged by its user or any third party.
The claims procedure: http://www.fenixgroup.eu
Protect the environment!
Please, throw paper packaging of the product to separated waste.