Evoko Room Manager Setup IBM Domino (v1) - Manual (Page 9)

EVOKO ROOM MANAGER Installation instructions (v1)
www.evoko.se
Configure Settings in the Evoko Control Panel
Select the Evoko Room Manager on the device selection page.
Now the Evoko Room Manager application needs to be configured with
some basic information in order to be able to connect to the IBM Domino
server. This is done via the Evoko Control Panel.
N.B.! The Evoko Control Panel is only used by the System Administrator for the initial
setup and is never employed by the end user.
Using the Evoko Control Panel from a previous installation
If you have installed a previous version of the Evoko Control Panel or Evoko
Configurator and have exported these values to a USB stick, please click
“Import” button instead of selecting server.
Double check all settings to make sure they are correct. Depending on
your previous version you may have to add more information.
Using The Evoko Control Panel from a new installation
The basic configuration needed in order to make Evoko Room Manager
work has to be entered into the Evoko Control Panel and then exported to
the Evoko Room Manager.
We recommend using the installation guide when configuring for the first
time. These are the steps to follow:
N.B.! Make sure that you install and run the latest available Evoko Control Panel from the
Evoko web site.
N.B.! You always find the most updated instructions and help by clicking the ?-button in
the Evoko Control Panel.
Server choice
First of all you need to select your server - IBM Domino.
Go to the next step by clicking the ”Continue to connectivity settings”-
button.
Server
Choice
Connection
Settings
System
Properties
Admin
Credentials
Dashboard
Export to
USB