D-Link DFE-530TX+ - Manual (Page 3)

Copyright Statement
No part of this publication may be reproduced in any form or by any means or
used to make any derivative such as translation, transformation, or adaptation
without permission from D-Link Corporation / D-Link Systems Inc , as
stipulated by the United States Copyright Act of 1976
FCC Certifications
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not Installed and used in accordance with the
instructions, may cause harmful Interference to radio communications
However, there is no guarantee that interference
will not occur In a particular
installation, If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures
. Reorient or relocate the receiving antenna
. Increase the separation between the equipment and receiver
l
Connect the equipment into an outlet on a circuit different from that to
which the receiver IS
connected
. Consult the dealer or an experienced radio/TV technician for help
Shielded interface cables must be used in order to comply with emission
limits.
You are cautioned that changes or modifications not expressly approved by
the party responsible for compliance
could void your authority to operate the
equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to
the following
two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any Interference received,
including interference that may cause undesired operation.