D-Link DFE-530TX+ - Manual (Page 15)

DE-530TX Ethernet/Fast Ethernet Adapter for PC/ Bus
2.
If your order does not include the Boot ROM option, go
ahead to Step 3. If your order includes the Boot ROM
option, then install the Boot ROM Chip by plugging the
chip into the Boot ROM Socket on the DFE-530TX card.
The notched end of the Boot ROM Chip must be aligned
with the notched end of the Boot ROM Socket (opposite
alignment will cause destruction of the Boot ROM
Chip).
3.
Insert the contact edge of the DFE-530TX card into the
connector of any available PCI Bus Master expansion
slot. Press the card firmly into the connector and
ascertain that the card’s contacts are fully seated in
the connector.
4.
Install the bracket screw which secures the card to the
computer chassis.
5.
Replace the computer’s chassis cover.
6.
Reconnect the computer’s power cord, and switch
computer power on.
If the BIOS section of your
computer’s boot program is Plug and Play compliant,
then at power-up the BIOS will automatically configure
any newly installed DFE-530TX adapter.
NOTE: Due to
a
fault in some Plug-n-Play B/OS programs, it
happens occasionally that a newly installed adapter is
assigned an Interrupt Number which is already assigned to
another device.
In such a case, the conflict of Interrupt
Number will cause faults in the behavior of both devices.
Then it is necessary to run the CMOS Setup utility, and
manually assign
a
non-conflicting Interrupt Number.
8 I n s t a l l a t i o n