Global prefix/suffix — cont – Datalogic Scanning MAGELLAN 3200VSI User Manual
Page 83
Global Prefix/Suffix
Product Reference Guide
75
START / END
PROGRAMMING bar codes
Sets up to 20 characters each from the set of ASCII characters or any hex value from 00 to FF. To configure this feature, scan the
“START/END” bar code above to place the unit in Programming Mode, then the “Set Prefix” or “Set Suffix,” followed by the digits from
the Alphanumeric table in
representing your desired character(s). Reference the section,
, for more information. Exit programming mode by scanning the “START/END” bar code again (scan
“START/END” twice if less than 20 characters have been selected).
DEFAULT SETTING PREFIX: 00 (None)
DEFAULT SETTING SUFFIX: 0D (CR)
Set Prefix
Set Suffix