ETA Virtuoso - Manual (Page 23)

V. TROUBLESHOOTING
PROBLEM Cause Solution
Food is
undercooked
Too higher temperature is set
too short time is set
Information about temperature and time
can be found at the food label or in the
table
Too much food in the basket
Reduce the amount of food in the
basket, see the table
Steam goes out
of other places
than the vent
holes in the lid
The lid is placed incorrectly
Put the lid on the proper place of the
deep fryer
The permanent filter of fat vapours is
blocked or soiled
Clean the lid, see par. IV Maintenance
The frying oil
foams out over
the edge of the
container
There is too much oil in the container
Check, or reduce the amount of rying
oil so that it does not exceed the „MAX“
gauge
There is too much food in the basket Do not prepare more amount that
recommended in the table
Food contains residues of ice or too
much humidity
Remove residues of ice before frying
and dry food properly
The oil foams
too much during
frying
Food contains residues of ice or
much humidity
Remove residues of ice before frying
and dry food properly
The frying oil is not suitable for frying Use oil or fat suitable for frying
There are impurities in the deep fryer
accessories (food residues)
Clean the deep fryer accessories, see
par.IV.Maintenance
There is
unpleasant smell
going out of the
deep fryer
The frying oil is not fres replace the oil
The frying oil is not suitable for frying Use oil or fat, intended for frying. Do not
combine various types of oil or fat
The deep fryer is
not working
The power supply is not connected Check the cord, fork and the socket
The switch is not in the 0 position Turn the switch to the I position
The control panel was ot put on
propery
Slide in the panel properly to the fixing
bar (you will hear a clicking sound)
Safety heat lock is activated
Use a suitable tool and press the
„RESET“ button. If pressing the
“RESET” button does not help, contact
the professional service (see the list)
VII. ECOLOGY
If the size of the appliance allows, all the parts contain marking of the materials used
for production packaging, components and accessories as well as for recycling. The
symbols on the product or in the accompanying documentation mean that the electrical or
electronic product used must not be liquidated together with communal waste. To ensure
the appropriate liquidation take the used appliance to a collection point where it will be
accepted free of charge. Correct liquidation of the product helps to protect valuable natural
resources and helps to prevent a potential negative impact on the environment and human
health which can be the outcome of inappropriate liquidation of waste.
23
GB
/ 40