ETA Cuore - Manual (Page 20)

20
GB
/ 40
– When the appliance is in operation, prevent pets, plants or insects
to get in contact with it.
– After finishing work and before cleaning, always switch off the appliance and disconnect
it from power supply by taking the power cord connector out of the electric socket.
– Use the appliance in the working position only at places with no risk of turning over
and in sufficient distance from heat sources (e. g. heater, stove, grill, etc.), and wet
surfaces (e. g. sinks, wash basins, etc.)
– Use the appliance designed for this type only. Using another appliance can represent
a risk for the operator.
– Do not switch on the appliance without ingredients in it!
– Do not mix attachments (whisks E and hooks F). If there are accessories in the
propulsion unit ( E or F), you can not connect blender G at the same time and vice versa.
– Do not insert the accessories in any bodily orifices.
– If the propulsion unit is operating, do not remove the accessories (e.g. whisks, hooks,
blender), bowl, lid and do not fold out the bracket of the stand!
– Make sure the supply cord does not get between the rotating parts of the accessories.
– Working attachments can not be replaced during operation of the propulsion unit due to
safety.
– Before preparation, remove possible packages from food (e.g. paper, a PE bag, etc.).
– It is not allowed to modify the surface of the appliance in any way (e.g. using a
selfadhesive wallpaper, foils, etc.).
– Make sure that hair or loose clothes do not get into the accessories to avoid risk of them
tangling into the mixing blade.
– The maximum time of processing is 10 minutes. Then wait for 15 minutes, which is
necessary for the drive unit to cool down.
– Check if the switch A1 is in position 0 (off) before each plugging in of the appliance and
unplug the appliance after finishing work.
– Turn the device off and unplug from the power source by pulling the plug out of the
socket before replacing any attachments or accessible parts which are moving during
operation (before installing or uninstalling, before cleaning or maintenance).
– Always unplug the appliance from the power source when left unattended.
– Do not let children use the appliance without supervision!
– Do not process ingredients with temperature higher than approx. 80 °C.
– Never insert e.g. fingers, fork, knife, spatula, spoon into rotating parts of the
appliance and the accessories.
– If the processed ingredients begin to stick on the accessories (e.g. whisks kneading
hooks, blender knife), lid or container, turn the appliance off and clean the accessories
carefully with a spatula.
– Make sure the whisks do not hit the walls of the utensils during operation or do not get
stuck in the thick matter or frozen ingredients.
– Check the condition of the supply cord regularly.
– Prevent the supply cord to hang loosely over the edge of the working desk where
children could reach it.
– The power cord must not be damaged with sharp or hot objects, open fire, it must not
be sunk into water or bent over sharp edges.
– If you need to use the extension cord, it has to be uncorrupted and it has to comply with
the valid standards.