ETA Maesta - Manual (Page 29)

Problem Cause Solution
Iron is not heated. Power supply not connected Check the cord, plug and the socket
Thermostat regulation wheel is in
MIN position
Set the wheel to position • / •• / ••• or MAX
AUTO STOP function activated Move the iron for deactivation of the safety
function
Iron does not
create steam
There is no water in the container Pour water into the container
Steaming regulator is in 0 position Move the regulator into the steaming
position
Low temperature is set for
activating the DRIP-STOP function
Use the regulation wheel to set a
temperature, during which you can use
steaming and wait till the iron is heated for
using it
Iron does not
create steam
shock
Low temperature is set for
activating DRIP-STOP function
Use the regulation wheel to set a
temperature, during which you can use
steaming and wait till the iron is heated for
using it
The function of steam shock was
used too often during a short period
of time
Let the iron heat and wait for a while before
using the electric shock function again
Sprinkling
equipment
(additional spray)
does not sprinkle
water
There is no water in the container Pour water into the container
The water system is aerated Tighten finger on the additional spray
jet hole and at the same time press the
sprinkling device button several times
Water is dripping
from the ironing
plate
The lid of the pouring hole of the
container is not closed properly.
Close the pouring hole lid
The steam shock function was used
when temperature below ooo was
set
Use the regulation wheel to set
a temperature ••• or MAX
The SELF CLEAN button was
pressed during ironing
Do not use the SELF CLEAN function
After finishing ironing, the iron was
put into the horizontal position and
the steaming regulator is not in 0
position
Move the steaming regulator to 0 position,
empty the container and put the iron into
the rest position
Flakes and other
impurities are
peeled off the
ironing plate
Contrary to recommendation
undiluted water is used with
excessive hardness >15 °N
Use water diluted with distilled water
Clean the iron using the SELF CLEAN
function and steam shock
V. TROUBLESHOOTING
The iron is equipped with a permanent decalcification system ANTI CALC that does
not require maintenance. But the system cannot fully prevent creation of calcareous
sediments.
29
GB
/ 51