ETA Tonale - Manual (Page 35)

Problem Cause Solution
The ironing
plate is dirty or
it has brownish
colour High temperature is set Set the temperature by the thermostat
regulator
A2 that corresponds to the ironed
material so that the material is not burned on
the ironing plate
Laundry is not sufficiently rinsed and it
contains residues of washing powder,
softener or starch Clean the ironing plate (see Maintenance).
The ironing
plate surface is
scratched The plate was in contact with sharp and
hard objects while ironing During ironing, avoid contact with metal ob-
jects containing sharp edges and do not put
the iron on a metal base with sharp edges
and protrusions
There are wet
spots on the
clothing during
ironing Wet spots that appear on the clothing
after a period of ironing with steam are
caused by steam condensed on the
ironing board
Iron over the wet spot without steam until
it dries
Decrease the volume of steam
Use a suitable board (ironing board with
a perforated base material)
Steam leaks
from the boiler The water discharge screw is not
tightened properly Use the screwdriver to adequately tighten
the screw
Water leaks
from the boiler
Water may leak from the water tank
(when the tank is full) if you tilt the
boiler during manipulation or place it
on an uneven surface
Do not tilt the boiler when the water tank
is full
VI. ENVIRONMENTAL PROTECTION
If the dimensions allow, there are labels of materials used for production of packing,
components and accessories as well as their recycling on all parts of the appliance The
symbols specified on the product or in the accompanying documentation mean that the
used electrical or electronic products must not be disposed of together with municipal
waste. For proper disposal, hand them over at the special collection places where they will
be accepted free of charge. Suitable disposal of the product can help to maintain
valuable natural resources and to prevent possible negative impacts on the environment
and human health, which could be the possible consequences of improper waste disposal.
Ask for more details at the local authorities or at a collection site. Fines can be imposed for
improper disposal of this type of waste in agreement with the national regulations.
If the appliance is to be put out of operation for good, after disconnecting it from power
supply we recommend cutting off the power cord and in this way it will not be possible to
use the appliance again.
More extensive maintenance or maintenance requiring intervention in the inner parts
of the appliance must be carried out by professional service!
Failure to comply with the instructions of the manufacturer will lead to expiration of
the right to guarantee repair!
35
GB
/ 58